Making Rigs Query

Message

#1 Post by **chenz116** » Tue Jun 21, 2011 10:45 pm

Ive been making my rigs using 40lb shock leader.

Is this right or should i be using lighter line and just putting the shock on my reel.

#2 Post by **sea serpant** » Tue Jun 21, 2011 10:55 pm

you should always use the same breaking strain line for your rigs that you do yer shockleaders... i personall wouldnt go below 60lb...

#3 Post by **stevecrow74** » Tue Jun 21, 2011 11:45 pm

just use the 10:1 rule with rig body's the same as you would for shock leader.

10lbs breaking strain for every 1oz weight in lead.

#4 Post by **stevo74** » Fri Jun 24, 2011 5:46 pm

Match the rig body with shock leader but I would go lower for the snoods - 20 - 30lb

#5 Post by **gerryl** » Fri Jun 24, 2011 8:25 pm

m8 best thing ever done was bought small selection of good (Pro) rigs then used the basic's to create me own versions!..luv tryin new rigs and tis a great buss when ya startin catchin...best luck

#6 Post by **Conger** » Fri Jun 24, 2011 9:38 pm

I use 50 to 60lb for the main body of my rigs and as a rule i don't go below 30lb for my snoods,

gerryl wrote:m8 best thing ever done was bought small selection of good (Pro) rigs then used the basic's to create me own versions!..luv tryin new rigs and tis a great buss when ya startin catchin...best luck

Gerryl your spot on, when i started to make rigs did the same, some crack when you start catching on your own rigs

#7 Post by **keith** » Sat Jun 25, 2011 12:34 am

If you are casting any distance then your rig body should be the same breaking strain as your leader, BUT if you are fishing for flats and bass in the breakers and not casting hard 40lb and even lower is fine a 60lb trace body fishing 10 yards out is overkill IMO...................

Sea Angling Ireland