reassembling mag elite - help needed!

Message

dwdw1 · #1 Post by **dwdw1** » Fri Dec 02, 2005 10:02 am

I've just dismantled my mag elite to oil the bearings, and naturally now I can't get the magnetic control inder the left end plate to go back together. Has anyone got a photo of how the mechanism should look? I've loked at the schematics but they aren't clear enough. Any help greatly apprecaiated.
DW

#2 Post by **beachcaster** » Fri Dec 02, 2005 11:09 am

the long one goes up the side of the cage and the short one goes in the bottom of the black mag holder ,faceing out towards the side plate.before putting the screws in check the slider works.

dwdw1 · #3 Post by **dwdw1** » Fri Dec 02, 2005 1:26 pm

Mnay thanks, It's the long brass or whatever piece that I'm stuck with. It seems to block the slider from closing the end plate.
cheers
David W

dwdw1 · #4 Post by **dwdw1** » Fri Dec 02, 2005 1:35 pm

Mnay thanks, It's the long brass or whatever piece that I'm stuck with. It seems to block the slider from closing the end plate.
cheers
David W

dwdw1 · #5 Post by **dwdw1** » Fri Dec 02, 2005 1:35 pm

Mnay thanks, It's the long brass or whatever piece that I'm stuck with. It seems to block the slider from closing the end plate.
cheers
David W