jb weld

Message

#1 Post by **g agus t** » Mon Apr 25, 2011 3:35 pm

does anyone know where i can buy J-B WELD....preferably in the cork region.

its a cold weld epoxy

cheers

#2 Post by **mickser** » Mon Apr 25, 2011 6:42 pm

give this crowd a try http://www.ect.ie/ their very helpful and if they cant help you thet will tell you where to go

#3 Post by **JimC** » Mon Apr 25, 2011 9:34 pm

PR Reilly are the agents. I would imagine that Autozone( (021)4354344) in Little Island would have it. I think I may have seen it there. Other than that local motor factors that deal with Reillys may have it.
Failing that Reillys are on line: http://www.team.ie/search_display.php?view=ALL

#4 Post by **g agus t** » Thu Apr 28, 2011 12:18 pm

mickser wrote:give this crowd a try http://www.ect.ie/ their very helpful and if they cant help you thet will tell you where to go

i tried Reilly's in dublin first and they had it. thanks anyway mickser

#5 Post by **g agus t** » Thu Apr 28, 2011 12:22 pm

JimC wrote:PR Reilly are the agents. I would imagine that Autozone( (021)4354344) in Little Island would have it. I think I may have seen it there. Other than that local motor factors that deal with Reillys may have it.
Failing that Reillys are on line: http://www.team.ie/search_display.php?view=ALL

thanks JimC. Autozone didnt have it nor did a lot of the motor factors. Reilly's were very efficent. Ordered it online....had it the next day....postage and packing was free. thats what i call service. hopefully i can get corrosion problems in the water pump sorted now. thanks again

#6 Post by **g agus t** » Sun May 01, 2011 9:47 pm

the jb weld seems good stuff. on deciding to change the impeller i got a shock when i lifted the plate underneath it. im not experienced in doing repairs like this but i decided to give it a go anyway. luckily i had a dremel drill which proved invaluable.

#7 Post by **g agus t** » Sun May 01, 2011 10:48 pm

underneath the pump

#8 Post by **g agus t** » Sun May 01, 2011 11:00 pm

looking ok ??

#9 Post by **JimC** » Sun May 01, 2011 11:55 pm

Looks good. Hopefully all will go well.

#10 Post by **MAC** » Tue May 03, 2011 1:04 pm

Looks like a nice repair... You might have had a little water ingress, so I would be inclined to remoce the drive shaft as well and check for corrosion or oxidation on the shaft. A light sand with some 800 grid wet and dry should sort it. New Gear oil and off you go.

Kev

Sea Angling Ireland

jb weld

jb weld

Re: jb weld

Re: jb weld

Re: jb weld

Re: jb weld

Re: jb weld

Re: jb weld

Re: jb weld

Re: jb weld

Re: jb weld