Anybody know where I can get some watch and pyramid leads?

[JOHN LYNCH]

Anybody know where I can get some watch and pyramid leads? I am based in Limerick. Would also be interested if anyone on the site makes them to sell.

Cheers.

[Tanglerat]

I think I saw some, both kinds, in the Donegal Angling Center when I was last there. dunno, wasn't paying attention. Too busy haggling.....

Give John a call on +353 (0)74 91 68496 or 087 2929888. Top bloke, he won't mind a chat.

Postage might be a killer, though.

[Shambo]

I think I saw some, both kinds, in the Donegal Angling Center when I was last there. dunno, wasn't paying attention. Too busy haggling.....

Give John a call on +353 (0)74 91 68496 or 087 2929888. Top bloke, he won't mind a chat.

Postage might be a killer, though.

He definitely had watch leads last time I was in anyway, and he does free delivery on orders over €25!

[JOHN LYNCH]

Thanks for the replies but Donegal is a tad too far for me. Anywhere in Cork??

[bhoy32]

I'm almost certain landers in tralee stock both of them and cork angling centre stocks the pyramid leads

[thescotsman]

In Cork? - Pretty Sure Dan in halfway angling has them, he certainly did when last I bought them from him.

http://www.tackledirectireland.ie/

[red]

In Cork? - Pretty Sure Dan in halfway angling has them, he certainly did when last I bought them from him.

http://www.tackledirectireland.ie/

dan definatly has them, spotted them last week and their on his site here
https://www.tackledirectireland.ie/inde ... 73udtar032

[JOHN LYNCH]

Thanks Lads,

I will give landers a try first and if not there I will try Cork as I'm down that way in a couple of weeks.

[baitdigger]

Mick out at Fanore post office had both last year. I am not sure if he sent the pyramids back for re-molding, I had a few off him and he said they didn't sell well. He definitely has the watch leads though.

[Al and Jordan]

if you can't get your hands on the watch leads you can make them pretty easily yourself on the cheap. no need for moulds just get a packet of those tea tree lights out of the euro shops. the wee candles in the aluminum holders and take the candles out and use them as your mould. give a wee bit of stripped copper wire a twist as a clip and your good to go man. you can vary the weight of them by how much lead you pour into them. i make them from 2oz to 5oz and they are the buisness for fishing beaches with a bit of surf where you don't have to use a gripper. lifesavers espically when there is a bit of weed about . i also give them a bit of a modification for estuary fishing over soft muddy beds. to ensure the lead dose'nt get buried in the mud i give them a wack while they are still hot when i rip them from the mould with a block hammer and it flattens them out to sbout the size of a rich tea biscuit . in these hard finincial times every penny counts man

[hughcronin]

did you get sorted Johnny, if your baddly stuck I can give you a few cause won't be using em in near future. you around kerry over the Easter. I havn't been able to wet a line all winter, way too busy. But intend doing some serious fishing at easter.

PM on your mobile

[JOHN LYNCH]

Hey Hugh, good to hear you'll be getting out over easter. I will deffo be up for a bit of fishing easter weekend. At the moment trying to replace all the fishing gear I sold, expensive stuff.