making a finger protector for casting any ideas

Just what it says above any ideas let me know.

just but one of the new mustad ones mate, they are dirt cheap!

Could use a rubber thimble used for sewing seen them used before by some english anglers

Old glove . Leather is good . Haven't tried eg rubber but don't see why not .
Cut from between the fingers up to the wrist , so you've got the finger bit with a couple of straps attached . Sew a loop of elastic to the end of the straps - put your hand thru' this - like a normal glove - it keeps the finger bit on for casting but means you can easily slip it off ( without loosing it ) when you want to .
Alternatively forget the elastic . Just fold the straps under between your palm and the rod handle .
Good luck

were did you get the mustad one and how much was it. Ps did you send info to me on the club mate

A rubber gardening glove with all the other fingers cut off is what i use, does the job fine

Use the side of the spool not the top of the line to brake the spool. and move the knot to one side of the spool when casting. Try it with out any protector its will become easy. I never use one and i fish with a 525mag