Daiwa TDXU
Fri Dec 04, 2009 10:27 am
I recently bought a Daiwa TDXU, which I received yesterday…..Happy days…..not quite 
It doesn’t seem to fit together. The spigot on the handle section of the rod seems to be too big diameter wise to fit inside the rod section. If the spigot is 4” long, it only slides about 3” in. I didn’t have much time to fiddle with it last night as I was heading out, and I don’t want to force it incase I end up breaking the rod.
Should it be so tight? Has anyone had similar problems with these rods?
It doesn’t seem to fit together. The spigot on the handle section of the rod seems to be too big diameter wise to fit inside the rod section. If the spigot is 4” long, it only slides about 3” in. I didn’t have much time to fiddle with it last night as I was heading out, and I don’t want to force it incase I end up breaking the rod.
Should it be so tight? Has anyone had similar problems with these rods?
Re: Daiwa TDXU
Fri Dec 04, 2009 11:33 am
i dont know the rod in question , but if it is a spigot joint it's fine it just allows for ware in the joint, if it pushed all the way in it wouldnt be long before you had a rod that was too loose fitting.
dont force the rod together you might not get it apart so handy
dont force the rod together you might not get it apart so handy
Re: Daiwa TDXU
Fri Dec 04, 2009 11:47 am
Ah....ok, thanks for the quick reply, this is the first rod Ive had with this type of Joint!