More Ball work on Technique

Well with the last of my holidays now here I thought I would go out again and do some technique work , I had hoped to cast a lead but people and car issues precluded me from doing this.

I was working on a consistent back swing as well as arm placement to get a better final finish and left arm pull working. After discussion with a very good friend who has helped a number of other casters overseas I decided I would heed his advise and increased my arm spacing more than I had. I did this in increments till I felt I was able to get into a good final finish position.

Here is the video footage that I took after getting to where I felt best with the arm position. I have taken the clips from different angles to ensure that I was achieving what I had hoped for. All in all I ma reasonably pleased with the results and am looking forward to getting out on the 175 and 200 gram leads later next week.

Any comments or feedback is welcome and appreciated.

http://youtu.be/oHbknCGD8bI

its not raining

Some nice sharp casts there jeremy, nice clean hits too well done.

Thanks for that Paddy , I have found that the regular short session are much better for my consistency as well as working on problem areas.

Regards