spinners

Hi Lads
Iwas given a pack of rubber spinners i think there called shads how do i attach these to hooks

well it depends if youve got leadheads or not

if you got the leadheads push the rubber shad using the thick end on the point of the hook

curve the shad along the bend of the hook so that the hook breaks the shad ruffly 1/2 to 2/3 further down towards the tail end - make sure the free tail end is on the same side as the hook

try to keep the hook to the centre of the rubber mass as best you can - otherwise it will stick out at an angle

if your using hooks push the shad as mentioned above as far as the eye/spade of the hook and then place the required weight further up your snood

thats basically whats required for any rubberfish/shad type lure

good luck