fishing gear transportation options

hi lads

im after changing my van but this newer one is different than the old one.this one now has a full bulkhead at the back of the seats so i might be pushing my luck trying to squeeze 7ft half lenght rods in.so im planning to buy roof bars

is it ok to clip them the rod bag straight on to it with bungee spring ties??or is there additional things i can put on the roof bars for extra strenght and security

also theres carpet in the backi.i plan to take this out.can any of ye recommend a type of non slip floor i can put down,in which is easy to clean and where id get it

thanks for any replies recievied also also hurry up with them as im dying to get fishing...

brian

For the back of your van: www.astauto.com.au/vanmats for a professional job, or www.mayomats.com for a DIY job. Best of luck with the van anyway!

What van hav ye got. Take out the panel if ye can behind seats. Should screw out wit star heads. That's what I done. Hav a Nissan. Rods go down middle of van and into middle of seats. If ye know anyone in a school or works in a hygiene service to get the big mats wit rubber back in them. There great. Easy to Hoover and ye can power wash them too

mooooooooooooooooooooooooooooooooooooooooooo

For the back of your van: http://www.astauto.com.au/vanmats for a professional job, or http://www.mayomats.com for a DIY job. Best of luck with the van anyway!

Hi Brian, if your gonna use a roof rack i would get a 8-9ft length of 4-6" waste pipe that you can put a cap on both ends. But what i done to my merc vito was cut a Hole in the bulkhead below the drivers seat and still used the waste pipe for a bit of protection. Good luck with the new van anyway...

i know a guy here that has cow mats behind his bar actually and swears by them

thanks for your comment.im not too sure if il be cutting anything thou.im just afraid if i put them on the bars that they will slide like mad

Hi Brian, if your gonna use a roof rack i would get a 8-9ft length of 4-6" waste pipe that you can put a cap on both ends. But what i done to my merc vito was cut a Hole in the bulkhead below the drivers seat and still used the waste pipe for a bit of protection. Good luck with the new van anyway...

http://www.fishingmegastore.com/flambea ... ~3168.html