multiplier serviceing

hi all would anyone have a link on how to service me slosh30 and penn 525mag xtra.there badly due one.never done it before so should be interesting to see how much the difference of preformance before and after serviceing

thanks brian

I have same reel,just put all the parts in order as u take them appart,i use wd40 on the bearings just soak em for a while in a bottle cap with wd40 ,then spin them and wipe,repeat until clean wd comes out,push bearing onto a biro then spin helps to hold em tight,be careful u dont loose the little screw that holds the end cap on its tiny,then oil lightly with a thin oil,i rarely strip the handle side no need unless its full of sand,just the spindle and bearings is all ye realy need to do hope this helps

Have a look on this guy's site he's very good.
www.alantani.com

Helped me to strip down a Shimano charter special which was fairly knackered.


Yappo

For the Penn 525 have a look at this:

http://www.torquedfishing.com/pdfs/StuCleaning525.pdf

And whatever you do, do not use anything else but lighter fluid to clean the bearings and rocketfuel to lubricate.
Most other products leave a residue that becomes sticky over time and a PAIN to clean afterwards.