Fri Jun 24, 2005 9:53 am
Hi all,
I have a Coleman Powerhouse two mantle petrol lamp in the shed for a couple of years now. I was having problems with it previously, so bought a headlamp to replace it.
I'd like to see if I can get it going again however.
The problem is that when I light it, the lamp tends to produce a flame, and when it's gone the mantles only produce a very dull, and flickering glow, before going out after about 10 mins.
Has anyone with one of these lamps suffered similar problems? I've tried all the usual tricks (making sure it's fully pumped, turning the nozzle from on to off to clean it etc), but it ain't working!
Also, does anyone know somewhere where I can send it to be repaired?
Any advice would be greatly appreciated!
Fri Jun 24, 2005 10:58 am
Coleman UK PLC
Gordano Gate Bristol BS20 7GG
United Kingdom
Ireland
Phone: + 44 (0) 1275 845024
Fax: + 44 (0) 1275 849255
E-mail:
consumerservices@colemanuk.co.uk
They wil be able to advise you where to get it repaired
b0ogaloo
Fri Jun 24, 2005 1:57 pm
Excellent - thanks!
Tue Jun 28, 2005 6:58 pm
Hi
It may be the jet is blocked or that you are using stale (old) petrol. Try new fresh petrol, only my suggestion, may not work.
Wed Jun 29, 2005 12:06 am
have you tried using Colman's white fuel, its a purified version of unleaded petrol. I've been told that if you use that every now and again it clears out any build up on the burners..
Wed Jun 29, 2005 12:08 pm
Cheers lads - thanks for the suggestions. Will give them a shot!
Sun Jul 10, 2005 3:59 pm
hi Mate.
I had the same probs with my lamp.
Check out - Andy Eddy - 01934814276. Registered repair/spare parts centre for colemans products ( He may also give good advice if Asked)
But his workshop is only open for Phone calls for a few days per week Wed +Thur
Hope this helps.
Sun Jul 10, 2005 6:55 pm
sounds like a generator problem but i could be wrong
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.